2.5" is as thin as i would go. I am 6'3" at 195lb (200lb in winter w/ 5/4 mil) so typically 2.5" thick is on my step-up board.
I CBD'd a 6'1" x 20.75" x 2.56" (-0.125 nose & -0.125 tail) and got 36.43L vol. (i like float, so no issue going up in volume..)
Loving the CBD tool. They should have it for more models (then they currently have), though im guessing it's expensive
6 results in 0.00 seconds.
-
-
Than you! much appreciated.
I will do the same.Leave a comment:
-
Hey prjwebb , thanks!
soo you'r saying to start from a 6'2" and shave off from there...?
btw i am not getting the new vol. on CBD after applying changes to nose width, thickness etc...Leave a comment:
-
Dominator CBD question
This question goes to the 'expert' guys...
I had a 6'2" dom. stock dims and volume. Liked it, but felt it was some what clunky / chunky for me (loved the flex)
i want to shave few liters(+/-) off and maybe refine the rails bait. Stay at the ~36lit vol.
The question is what CBD dims would you suggest?
Thanks! -
Thanks everyone for the suggestions, since i am getting an FCS plug BP i thought of Greg Griffin G10-s
or as simple as m7 fronts w/ GX rears...? I am gonna surf this board in NJ small surf, soo i don't know if i am over fin-ing it or under fin-ing it..?
Keep on with the good suggestions.
Thanks.Leave a comment:
-
Fin setup for BP
getting a 5'9" BP and trying to figure a quad fin configuration for it.
Im 6'3 (192cm) at 195lb (85kg) and usually go w/ a bigger fin template.
Have a 5'8" SP w/ controllers and had mix results.
help / suggestions are appreciated.
Thanks.
Leave a comment: