Just received my indo controllers in the post yesterday, they look really a lot nicer than I was expecting, so im happy for the price, iv been using c drives in my sweet potato which i have been really impressed with (generate a ton of speed) but wanted to see how the indo controllers compare after reading all the positive feedback.
Only thing is the front left fin is a little lose, id say its about a mm not thick enough in the tab and i can move it slightly in the box. Most fcs fins stay in if you turn the board upside down without doing the screws up but this one falls out. However, as soon as I do the screws up it feels as solid as any other fin.
Anyone got any ideas whether it would be worth putting a bit of epoxy resin or fibre glass cloth over the lose tab to make it a little thicker? would it stick? It is tight when the screws are done up so maybe its worth just not worrying about.
Not keen on sending them all the way back to indo,